Frequently asked Questions
Index

 
  1. I can't get the Channel Controller into Programming Mode. I press the [ADDRESS] button but nothing happens.
  2. I can't get the Channel Controller into Programming Mode. I press the [SYS_INFO] and some numbers go by then the Channel Controller's display just starts flashing.
  3. I want to use a Channel Controller for a video account but every 5 minutes the on screen graphics come up.
  4. When entering channel numbers the receiver sometimes goes to the wrong channel, but the correct number displays on the Channel Controller.
  5. The Channel Controller doesn't respond to anything, but I know my batteries are good.
  6. The Channel Controller doesn't select the correct receiver channel. (When I watch with a video monitor I see some of the digits are wrong.) Also, the receiver seems to work fine with a remote.
  7. The Channel Controller doesn't select the correct receiver channel.
  8. I have a Model 3900 receiver or other receiver with the plexiglass cover and the foam tape mask / mount does not seem to do the job.
  9. I only have 5 or 10 channels that I want in my channel list. Do I have to go through and delete all the others.
  10. How do I check to make sure that I'm not getting commands from the Remote leaking through directly to the receiver.

 

 

 

 

 

 

 

 

 

© 2002 PMP Systems, Inc.